Operating the Baler in Cornstalks

Cut stalks prior to baling to improve pickup tooth life.

Raise machine and lower the pickup (teeth do not have to touch the ground) to increase the feed opening.

Do not rake more than six rows together or plugging may occur at the pickup area. Higher productivity can be obtained by baling smaller windrows at faster ground speeds.

Be sure to maintain rated PTO speed.

In Case Of Baler With Precutter Device:

If stalks have not been cut prior to baling, put precutter knives in cutting position and slowly drive over the windrow to improve pickup tooth life.

CC,570RB003464 -19-15SEP98-1/1