Removing and Installing Net Feed Roll Drive Belt

Remove net feed roll drive belt as follows:

Fully retract net actuator. Slightly open gate to release pressure on baler belts.

Remove gate roll NR 8 fixing screw (A).

Remove idler (B) from bracket (C).

Remove fixing screws (D) then remove roll support (E) with idler (B).

Remove drive belt (F).

Reverse removal procedure to install drive belt back in place.

Close the gate and check belt tracking. See "Adjusting Belt Tracking" in this Section.

A-Gate roll fixing screw
B-Idler
C-Bracket
D-Fixing screws
E-Gate roll support
F-Drive belt

CC,570RB003759 -19-01SEP98-1/1