Adjusting Soft Core Diameter

The gate must be closed and the tension arm all the way down before making soft core diameter adjustment.

Adjust as follows:

Loosen wing nut (A).

Turn cam (B) until desired mark is level with switch roller (C). Adjusting ranges are:

• From "1" to "4.5" on 570 baler.
• From "1" to "5" on 580 baler.

Tighten wing nut (A) and check that cam (B) is still aligned with switch roller (C).

IMPORTANT: Diameter of soft core should never be greater than bale size selected.

A-Wing nut
B-Cam
C-Switch roller
D-Switch

CC,570RB003871 -19-15SEP98-1/1