|
Crop accumulation at starter roll.
|
Scraper too far from starter roll.
|
Adjust scraper. See "Operating the Baler - General Purposes" Section.
|
|
Belt(s) slipping.
|
Too heavy silage bales.
|
Reduce bale diameter
1
.
|
|
|
Wet conditions.
|
Install upper roll drive kit. See "Attachments" Section.
|
|
Difficulties when starting a bale (wet crop due to rain).
|
Core does not start to turn.
|
Discharge the core and start to bale at the lowest rpm until the core starts turning. See "Baling Silage" in "Operating the Baler - General Purposes" Section.
Bale when dry matter content is 40 %.
|
|
Crop accumulation at the staggering roll.
|
Silage bundle not installed on baler.
|
Install silage bundle on baler. See "Attachments" Section.
Raise and lock the gate. Stop tractor engine and clean staggering roll.
|
|
Plugging the baler by feeding a too large bunch of silage.
|
Irregular windrows.
|
Re-engage PTO at lowest engine rpm. If unsuccessful, then discharge bale and clean inside of baler. See "Unplugging the Baler" in "Operating the Baler - General Purposes" Section.
Reverse precutter drive. See "Operating the Baler - BaleMaster Control Monitor" Section.
|