Adjusting Upper Arm Cylinder (580 Baler Only)

If hydraulic cylinder (A) has been replaced, adjust cylinder as follows:

Close the gate and lower the belt tension arm.

Pull out cylinder rod (B) until dimension (C) is:

  • 261 mm (10.27 in.) on 580 baler up to SN 318481.
  • 255 mm (10.04 in.) on 580 baler from SN 318482.

Install and screw in strap (D) so that it is possible to install cylinder fixing screws (E).


A-Hydraulic cylinder
B-Cylinder rod
C-261 mm (10.27 in.) up to SN 318481; 255 mm (10.04 in.) from SN 318482
D-Strap
E-Fixing screws

CC010042

CC,570RB003901 -19-01SEP98-1/1