Adjusting Gate Latch Switch (590 Only)

Close and latch gate. Cylinder should be fully retracted.

Loosen cap screw (A).

Turn switch bracket so that switch roller (B) is centered on short leg of ramp.

With switch arm contacting switch body, adjust switch bracket to obtain a distance of 0.5 to 2 mm (0.02 to 0.08 in.) between switch roller (B) and ramp (C).

Adjust bracket on switch using cap screw (A) and/or screws (D) to obtain correct dimension.

Retighten cap screw (A).

Repeat procedure on the opposite side.

A-Cap screw
B-Switch roller
C-Ramp
D-Adjusting screws

CC,570RB003906 -19-15SEP98-1/1