Adjusting Pulley Sensors

Rotate pulley (A) so that the magnet (B) is just aligned with sensor (C).

Distance (D) should be 2 to 4 mm (0.078 to 0.157 in.). If not, loosen lock nuts (E), then slide sensor (C) until specified distance (D) is achieved.

Slightly tighten lock nuts (E) and rotate the pulley several times to check that there is no interference between sensor and magnet.

A-Pulleys
B-Magnet
C-Sensor
D-2 to 4 mm (0.078 to 0.157 in.)
E-Lock nuts

CC,570RB003917 -19-15SEP98-1/1