Adjusting Soft Core Switch

Close the gate, then loosen switch mounting screws (A).

Position switch roller (B) on highest (numbered) portion of cam (C).

Adjust switch to approximately 1 mm (0.04 in.) clearance (D) between switch body and switch arm.

Tighten screws (A).

NOTE: On baler equipped with Electronic Wrapping Control Monitor, the second cam (E) is the bale size cam.

CC001274


A-Screw
B-Roller
C-Soft core cam
D-1 mm (0.04 in.)
E-Bale size cam

CC,570RB003933 -19-15SEP98-1/1