A-START key (Manual start)
B-DEERE key: Measurement units, Diagnostic mode, Reset monitor
C-PLUS key: Increase, Reset/Switch/Display
|
D-AUTO key: Auto/Manual mode, Bale size, Fine tune
E-COUNTER key: Bale counter, Baler model
F-MINUS key: Decrease, Reset/Switch/Display
G-SOFT CORE key
|
H-EXTEND key
I-RETRACT key
J-BALE SIDE WRAP key
K-WRAP DENSITY key
L-RE-EXTENSION key: Re-extension, Flax wrapping mode, L.H twine wrap reduction
|
M-R.H WRAP key
N-L.H WRAP key
O-PRECUTTER key: Precutter operating modes
|
