Adjusting Bale Start Wrap Position

The start position of wrapping can be adjusted from 0.08 to 0.25 m (3.14 to 9.85 in.). This is the distance (A) from the right-hand side of the baler to the tip of the main twine arm (B). During twine wrapping cycle, twine arm (B) will run up to this position and stay there according to the setting selected by the operator under "Adjusting Bale Side Wrap" in this Section.

NOTE: The start position of wrapping can be adjusted from 0.08 to 0.55 m (3.14 to 21.65 in.) when using monitor in flax wrapping mode. See "Selecting Flax Wrapping Mode" in this Section.

Display and adjust the start wrap position as follows:

Switch ON monitor in twine mode position.

Press and hold R.H. WRAP key to display the current position. If this one is no longer required, keep on holding R.H. WRAP key while pressing PLUS key to increase the distance, or while pressing MINUS key to decrease it.

Release R.H. WRAP key to store the last distance entered.

NOTE: A short pressure on PLUS or MINUS keys gives an increment of 0.01 m (0.39 in.). A long pressure on those keys accelerates the increment display.

CC,570RB003968 -19-15SEP98-1/1