Adjusting Bale Side Wrap

The number of twine coils at the start and end wrap position, determined by the operator as described in "Adjusting Bale Start Wrap Position" and "Adjusting Bale End Wrap Position" in this Section, can be adjusted from 0.1 to 10.

Display and adjust number of coils as follows:

Switch ON monitor in twine position.

Press and hold BALE SIDE WRAP key to display the current number of coils. If this one is no longer required, keep on holding BALE SIDE WRAP key while pressing PLUS key to increase the number of coils, or while pressing MINUS key to decrease it.

Release BALE SIDE WRAP key to memorize the last number of coils entered.

NOTE: A short pressure on PLUS or MINUS keys gives an increment of 0.1. A long pressure on those keys accelerates the increment display.

The number of twine coils at end wrap position (L.H. side) can be reduced by using RE-EXTENSION key. This allows to get less number of twine coils at the L.H. side than on the R.H. side of the bale (see "Reducing L.H. Side Number of Twine Coils" in this Section).

CC,570RB003970 -19-15SEP98-1/1