Wrapping a Bale-Automatic Net Wrapping Mode (Manual Start)

Whenever necessary, the automatic net wrapping mode can be manually started by pressing START key. This allows starting the wrapping cycle before the bale diameter set by the monitor is reached.

1. Once START key is pressed, operator should stop forward travel of tractor and back up tractor 2 to 3 m (8 to 10 ft) (not necessary if baler is equipped with discharging ramp). The pictogram (A) appears on LCD screen and a short sound alarm (about 2 seconds) is emitted as the wrapping cycle is starting. All along the cycle, the pictogram (A) appears continuously.

2. When wrapping cycle is completed, pictogram (A) disappears and a short sound alarm (about 1 second) is emitted.

3. If the net has not been cut, pictogram (A) (flashing) and (B) (continuous) will appear and a continuous sound alarm will be emitted until:

  • Net is cut,
  • or START, EXTEND or RETRACT key has been pressed.

NOTE: If the net roll is empty, pictogram (A) (flashing) and (B) (continuous) will appear and an intermittent sound alarm will be emitted.

The bale can now be discharged. See "Discharging Bale" in this Section.

CC007145

CC,570RB003993 -19-15SEP98-1/1