Wrapping a Bale-Manual Net Wrapping Mode (Programmed Start)

In this mode, the net wrapping cycle must be tripped by the operator with the help of the pictograms displayed on LCD screen or sound alarm which will inform when to stop tractor forward travel and when to discharge the bale.

1. Once the preset bale diameter is reached, flashing pictogram (A) appears on LCD screen as the net wrapping should start. Operator should stop forward travel of tractor and back up tractor 2 to 3 m (8 to 10 ft) (not necessary if baler is equipped with discharging ramp) and press START key to start the wrapping cycle.

2. Pictogram (A) becomes continuous and a short sound alarm (about 2 seconds) is emitted as the wrapping cycle is starting. All along the cycle, the pictogram (B) appears continuously.

3. When wrapping cycle is completed, pictogram (B) disappears and a short sound alarm (about 1 second) is emitted.

4. If the net has not been cut, pictogram (B) (flashing) and (C) (continuous) will appear and a continuous sound alarm will be emitted until:

• Net is cut,
• or START, EXTEND or RETRACT key has been pressed.

NOTE: If the net roll is empty, pictogram (B) (flashing) and (C) (continuous) will appear and an intermittent sound alarm will be emitted.

The bale can now be discharged. See "Discharging Bale" in this Section.

CC,570RB003995 -19-15SEP98-1/1