Checking Swinging Bar Position (Test 1)NOTE: The swinging bar position (in relation to the knife) must be checked if serious net cut problems occur during field operation. Proceed as follows: Fully retract net actuator (A). Look at each side of the net frame and check that swinging bar (B) is against net knife (C) all across its width. IMPORTANT: Contact should occur on the medium area of the sharp side of the knife as shown. If swinging bar is not fully in contact with the knife, add washers between swinging bar (B) and support (D) as necessary to obtain correct contact. Proceed to test 2.
|
|
CC,570RB004263 -19-15SEP98-1/1 |