A-Net actuator

B-Swinging bar

C-Side wall

D-Fixing pin

IMPORTANT: Prior to carry out this test, make sure that test 1 to 5 results are "OK". Proceed to the relevant tests described in this Section.

Proceed as follows:

Remove net feed roll drive belt. See "Removing And Installing Net Feed Roll Drive Belt" in this Section.

Fully extend net actuator (A).

Check that swinging bar (B) contacts the cutout in the side walls at (C).

Remove the lower actuator fixing pin (D). The actuator must have at least 4 mm (0.16 in.) of possible extension left.

If possible extension is less than 4 mm (0.16 in.) then check that cut of side wall (C) is not deformed or flattened.

Proceed to test 7.

CC,570RB004268 -19-01SEP98-1/1