Attaching to Tractor Hydraulic System (Baler Without Precutter Device)1

causym CAUTION: Maximum working pressure of round baler hydraulic hoses is about 20000 kpa (200 bar; 2900 psi). To avoid injury from escaping fluid under pressure, stop engine and relieve the pressure in the system before disconnecting or connecting hydraulic or other lines. Tighten all connections before applying pressure.

ISO hydraulic couplers are standard with the baler. If they do not fit the tractor, see your John Deere dealer for correct coupler.

1Double-acting pickup lift device shown

CC,570RB004383 -19-15SEP98-1/3

On Baler Without Hydraulic Pickup Lift Device:

Attach right-hand hydraulic hoses (A) to tractor receptacle to operate the gate. When tractor selective control valve lever is moved rearward, the rear gate should open.

E21606

CC,570RB004383 -19-15SEP98-2/3

On Baler With Hydraulic Pickup Lift Device:

Attach left-hand hydraulic hoses (B) to tractor receptacle to operate the pickup lift. When tractor selective control valve lever is moved rearward, the pickup should raise.

E26083

CC,570RB004383 -19-15SEP98-3/3