|
The following procedure should be carried out when net cut or wrapping problems occur during field operation.
The check procedure is divided in two main parts which include different tests to carry out:
Part 1 - With net actuator fully retracted
Tests to carry out are:
-
Test 1 - Checking swinging bar position
-
Test 2 - Checking net actuator retraction
-
Test 3 - Checking net feed roll brake
-
Test 4 - Checking steel roll/rubber feed roll parallelism
|
Part 2 - With net actuator fully extended
Tests to carry out are:
-
Test 5 - Checking drive pulley alignment (without drive belt)
-
Test 6 - Checking net actuator extension (without drive belt)
-
Test 7 - Checking net feed roll drive belt
-
Test 8 - Checking net wrapping cover hook
NOTE:
When all test results are "OK", the net wrapping device is then optimized for good field operation.
|