A-84 to 85 mm (3.30 to 3.34 in.)
B-Drive pulley

C-Rear gate side sheet
D-5 mm (0.20 in.) minimum
E-Idler pulley

F-Rear gate side sheet reinforcement

G-4 mm (0.16 in.) minimum
H-Roll NR 8 support

IMPORTANT: Prior to carry out this test, make sure that test 1 to 4 results are "OK". Proceed to the relevant tests described in this Section.

Proceed as follows:

Check that distance (A) between drive pulley (B) and rear gate side sheet (C) is 84 to 85 mm (3.30 to 3.34 in.). Add or remove washers as necessary.

Check that distance (D) between idler pulley (E) and rear gate side sheet reinforcement (F) is at least 5 mm (0.20 in.). Add or remove washers as necessary.

Check that distance (G) between idler pulley (E) and roll NR 8 support (H) is at least 4 mm (0.16 in.). Add or remove washers as necessary.

Reinstall net feed roll drive belt. See "Removing And Installing Net Feed Roll Drive Belt" in this Section.

Proceed to test 6.

CC,570RB005143 -19-07SEP99-1/1