Adjusting Net Roll Support Brackets

The purpose of this adjustment is to make sure that net roll is parallel to the net feed rolls when net wrapping is engaged.

Proceed as follows:

Open net wrapping cover.

Place straight edge (A) across both support brackets (B).

Make sure that contact (C) between the straight edge (A) and support brackets (B) is 80 to 140 mm (3.15 to 5.5 in.) from side panels.

If an adjustment is needed, put adjustable wrench (D) on upper edge of brackets (B) and bend brackets so that contact (C) is within specified dimension from side panel.

A-Straight edge
B-Support brackets
C-80 to 140 mm (3.15 to 5.5 in.)
D-Adjustable wrench

CC,570RB005145 -19-07SEP99-1/1