|
The following checks, adjustments and service jobs were performed prior to delivery of the machine:
1.
[ ] All grease fittings lubricated.
2.
[ ] Gear case oil level checked and topped up (if necessary).
3.
[ ] Slip clutch setting checked.
4.
[ ] All bolts and nuts have been tightened to the correct torque.
5.
[ ] Hydraulic hoses and connections have been checked and are free of leaks.
6.
[ ] Belt tracking checked.
7.
[ ] Tire pressure has been checked and adjusted (if necessary).
8.
[ ] Paint and decals are smooth and neat.
9.
[ ] Operator's manual has been given to customer.
10.
[ ] The net knife has been wiped.
|
11.
[ ] Talc to rubber coated net roll has been applied.
12.
[ ] Battery harness has been installed on baler equipped with BaleMaster monitor.
13.
[ ] Test run of the machine made.
14.
[ ] Gate opens and closes freely.
15.
[ ] Gate roll No 8 centered correctly in its hole.
16.
[ ] Net roll tensioning springs set to 20 mm (0.78 in).
17.
[ ] Bale control or monitor is functioning properly.
18.
[ ] Hydraulic gate latch is functioning properly (590).
19.
[ ] All controls and safety rules have been explained to the customer.
20.
[ ] Chains are correctly tensioned and lubricated.
21.
[ ] Baler belts are in contact with lower gate roll.
22.
[ ] The precutter device is functioning properly.
|