Adjusting Precutter Reverse Sensor

Check that precutter is not in reverse operating mode. See "Reversing Precutter Rotor" in "Operating BaleMaster Control" Section.

With hydraulic cylinder fully retracted, check that magnet (A) is aligned with sensor (B).

Distance (C) should be 10±1 mm (0.4±0.04 in.). If not, loosen lock nuts (D), then slide sensor (B) until specified distance (C) is achieved.

Slightly tighten lock nuts (D).

A-Magnet
B-Sensor
C-10±1 mm (0.4±0.04 in.)
D-Lock nuts

CC,575RB003923 -19-15SEP98-1/1