Adjusting Wheel Spindles-Baler with 1.81 m (5 ft 11 in.) Pickup
Feeding difficulties may occur in extreme conditions such as brittle dry crops or large windrows. This problem can be solved by adjusting clearance between ground and machine according to crop conditions. Three wheel spindle positions are usable: Position 1 must not be used. Position 2 is the shipping position, factory adjusted. This position can also be used in 3rd cut. Position 3 allows the baler equipped with 11.5/80 x 15.3 or 19/45 - 17 tires to be raised when baling large straw windrows. Position 4 allows the baler equipped with 15/55 -17 or 10.0/75 x 15.3 tires to be raised when baling large straw windrows. Tighten all wheel spindle bolts to 280 N·m (206 lb-ft). Make sure bolt heads face outward. |
|
CAUTION:
Always make sure that baler is securely supported by the jackstand before adjusting wheel spindles. Do not forget to block up wheel on opposite side.
OUCC006,0000210 -19-04SEP00-1/1 |