Diagnosing Twine Pulley 2 Sensor

The pulley No. 2 sensor (A) informs the monitor about the detection of pulley rotation which confirms that the twine has been caught by the bale during the automatic wrapping cycle.

Test the pulley No. 2 sensor as follows:

- Switch ON the monitor in diagnostic mode. See "Switching On Control Monitor In Diagnostic Mode" in this Section.

Rotate pulley (B) by hand until sensor (A) is aligned with magnet (C).

Press and hold COUNTER key to check that digits (D) display "0". If display is "5", the sensor (A) is not correctly adjusted or defective.

See "Adjusting Twine Pulley Sensors" in "Service" Section.

OUCC006,0000239 -19-19SEP00-1/1