OMCC50090: 570, 580 and 590 Round Balers( 322400- ), Block File: OUCC006_000023E_19

The net cut switch (A) is located outside the net frame and informs the monitor if the net has been effectively cut or if the net roll is empty.

Test the net cut switch (A) as follows:

Switch ON the monitor in diagnostic mode. See "Switching On Control Monitor In Diagnostic Mode" in this Section.

Push down stud (B) so that switch (A) is no longer activated.

Press and hold PRECUTTER key to check that digits (C) display "0". If display is "12", switch (A) is not correctly adjusted, connected or defective.

See "Adjusting Net Cut Switch" in "Service" Section.

OUCC006,000023E -19-19SEP00-1/1