|
Pickup teeth do not revolve.
|
Pickup drive chain broken.
|
Replace chain.
|
|
|
Pickup shear bolt sheared.
|
Replace shear bolt. See "Service" Section.
|
|
|
Broken cam.
|
Replace cam.
|
|
Pickup does not float or drop freely.
|
Excess or insufficient float assist.
|
Adjust float springs (except baler with 2.20 m; 7 ft 3 in pickup up to S.N. 327823). See "Operating the Baler - General Purposes" Section.
Lubricate float axles (for baler with 2.20 m; 7 ft 3 in pickup up to S.N. 327823). See "Lubrication and Maintenance" Section.
|
|
|
Binding at pivots.
|
Remove chaff and dirt. Make clearance between sliding parts.
|
|
Not picking up hay cleanly.
|
Pickup teeth set too high.
|
Lower pickup. See "Operating the Baler - General Purposes" Section.
|
|
|
Pickup stays up.
|
Loosen float springs. See "Operating the Baler - General Purposes" Section.
|
|
|
Ground speed too high.
|
Reduce ground speed.
|
|
|
Windrows too light.
|
Rake heavier windrows. See "Operating the Baler - General Purposes" Section.
|
|
|
Pickup teeth bent or broken.
|
Straighten or replace teeth.
|
|
Pickup teeth digging in ground.
|
Pickup set too low.
|
Raise pickup. See "Operating the Baler - General Purposes" Section.
|
|
|
Poor pickup floatation.
|
Tighten float springs and/or check pivots. See "Operating the Baler - General Purposes" Section.
|
| Symptom |
Problem |
Solution |
|
Pickup tooth breakage.
|
Pickup set too low.
|
Raise pickup. See "Operating the Baler - General Purposes" Section.
|
|
|
Foreign material inside and/or broken teeth.
|
Remove material and/or replace teeth.
|
|
|
Baling cornstalks.
|
Raise pickup. Higher tooth breakage can be expected. See "Operating the Baler - General Purposes" Section.
|
|
Pickup too high.
|
Wheel spindles in high position.
|
Lower wheel spindles. See "Operating the Baler - General Purposes" Section.
|
|
Plugging at flares.
|
Over-crowding ends.
|
Reduce crowding.
|
|
|
Pickup set too low.
|
Raise pickup. See "Operating the Baler - General Purposes" Section.
|
|
|
Tractor tires crushing crop into stubble.
|
Increase wheel tread. See "Preparing the Tractor" Section.
|
|
Inside of strippers worn.
|
Strippers bent up hitting tooth coils.
|
Check for binding at flares.
Increase float. See "Operating the Baler - General Purposes" Section.
Raise pickup. See "Operating the Baler - General Purposes" Section.
|