Adjusting Tension Cylinder Position (570 Only)

Two positions are available on the belt tension arm to fit the tension cylinders:

1. Position (A):

The baler factory set to this position. It allows to bale at normal density adjusted by the operator.

2. Position (B):

Moving tension cylinders to this position allow to lower bale density. This position is generally used with soft core (55 bar) to reduce density of bale core.

NOTE: Tension cylinders must be fitted in the same position on both sides.

A-Normal density position
B-Low density position

OUCC006,0000275 -19-30OCT00-1/1