Bleeding Platform Lift Circuit

This procedure is necessary when left-hand cylinder is setting down on cylinder lock and right-hand cylinder is fully extended. If left-hand side of machine does not raise up, bleed oil from right-hand cylinder according to following instructions.

1. Engage right-hand cylinder lock (A).

2. Wrap a rag around right-hand cylinder fitting.

3. Loosen fitting (B) and release oil until right-hand cylinder rests on cylinder lock.

4. Tighten fitting.

5. Raise platform and disengage cylinder locks.

6. Lower platform.

A-Cylinder Lock
B-Fitting

AG,OUCC006,145 -19-08FEB00-1/1