IMPORTANT:
All hydraulic couplers must be clear of debris, dust, and sand. Use protective caps on fluid openings until ready to make connection. Foreign material can damage the hydraulic system.
NOTE:
ISO hydraulic couplers are standard with the mower-conditioner. If they do not fit the tractor, see your John Deere dealer.
2.
Clean off dust covers (A).
3.
Check to be sure symbols (B) on receptacle identification plate, indicating cylinder movement, match cylinder travel direction.
4.
Insert platform lift hydraulic hose into "extended side" receptacle (C) (SCV I).
5.
Insert tongue swing hydraulic hoses into the next set of tractor receptacles (SCV II).
6.
Insert tilt control hydraulic hoses into the next set of tractor receptacles (SCV III).
7.
Push hoses firmly into tractor receptacles.
|