Every 200 Hours: Cutterbar-Changing Oil
1.
Shorten tilt control cylinder for flattest angle. (See Adjusting Cut Height in Operating the Mower-Conditioner section.)
2.
Run machine to warm cutterbar oil.
3.
Raise machine and engage cylinder lift stop on RIGHT-HAND side only.
4.
Put a container of about 15 L (4 U.S. gal) under cutterbar drain plug (A).
5.
Loosen sight glass with 7/8 in. (24 mm) socket. DO NOT remove sight glass at this time.
6.
Put wooden block under left-hand side of cutterbar.
7.
Lower machine onto wooden block.
8.
Remove right-hand sight glass to drain oil.
IMPORTANT:
Tighten sight glass to specifications. Do not over tighten.
9.
Reinstall sight glass after oil has been removed and torque to specifications.
Specification
Sight glass
-Torque
|
77 N·m
|
55 lb-ft
|
10.
Raise machine and remove wooden block.
11.
Disengage right-hand cylinder lift stop.
12.
Lower machine.
|