1.
Disengage tractor PTO.
2.
Position machines on a level surface. Firm soil or gravel is recommended.
If loading on a hard surface such as concrete or asphalt, engage transport system brakes (if equipped) or put wheel chocks in place to prevent trailer from sliding along hard surface during loading procedure.
3.
Fold tuck panels up to fully raised position. (See Adjusting Windrow Width in Operating the Mower-Conditioner section.)
|
4.
Start tractor engine and raise mower-conditioner platform.
5.
Activate tongue swing circuit to align centerline of tractor with right-hand side of platform. This gives operator better visibility while backing up.
6.
Align mower-conditioner wheels with transport ramps.
7.
Tilt the cutterbar to obtain the minimum cut height. (See Adjusting Cut Height in Operating the Mower-Conditioner section.)
|