13.
Continue extending tongue swing cylinder until tractor centerline aligns with right-hand side of mower-conditioner platform.
14.
Raise mower-conditioner platform. As platform raises, hooks at wheel supports unlatch from transport tubes.
15.
Tilt cutterbar to minimum cut height. (See Adjusting Cut Height in Operating the Mower-Conditioner section.)
16.
If unloading on a hard surface such as concrete or asphalt, engage transport system brakes (if
|
equipped) or put wheel chocks in place to prevent trailer from sliding along hard surface during unloading procedure.
17.
Slowly move mower-conditioner forward. Ramps will lower as mower-conditioner weight "shifts" off transport.
18.
Activate tongue swing circuit to move mower-conditioner to desired field operating position.
19.
Raise hitch until PTO driveline is level.
|