Removing Disks
NOTE:
If removing left-hand end disk, refer to Replacing Left-Hand End Converging Disk Driver in this section. If removing right-hand end disk, refer to Replacing Right-Hand End Converging Disk Driver in this section.
956 Machine; Disks next to both left and right-hand ends are equipped with short converging drums (B). The following procedures apply to all disks.
1.
Raise front doors.
2.
Put a piece of wood between either end disk and outer side sheet.
3.
Remove four cap screws (A).
4.
Remove short converging drum (956), if equipped, and disk from cutterbar.
A-Cap Screw (4 used)
B-Short Converging Drum
|