6.
Align timing mark on special washer (B) with mark on driver (C). Install washer.
IMPORTANT:
To avoid machine damage, use new M16 x 50 center cap screw treated with thread-locking compound.
Lubricate cap screw with light oil before installation. Failure to lubricate could allow cap screw to come loose and cause machine damage.
7.
Lubricate M16 x 50 cap screw (A) with a light oil. Install and tighten to specifications.
Specification
Disk Driver Cap Screw
-Torque
|
340 N·m
|
(250 lb-ft)
|
8.
Install disk in original position. (See Installing and Synchronizing Disks in this section.)
|