2.
Raise left-hand side front door to access drive sheave on gear case. (See Raising and Lowering Front Doors and Curtains in Operating the Mower-Conditioner section.)
3.
Remove shield (A).
A-Shield
946 Shown
OUCC006,00002AB -19-16NOV00-1/5
4.
Open door (A) by turning latch (B) with a suitable wrench or a screwdriver.
A-Door
B-Latch
OUCC006,00002AB -19-16NOV00-2/5
5.
Remove two nuts and washer (C).
6.
Remove cotter pins, pivot pin and idler (A).
7.
Remove cap screw, washer and impeller rotor sheave (B).
A-Idler
B-Rotor Sheave
C-Nuts and Washer
OUCC006,00002AB -19-16NOV00-3/5
8.
Remove drive belt from sheave (A).
9.
Pull out belt from rear of machine.
10.
Install new belt in reverse order of removal.
Tighten cap screw at impeller rotor sheave to specifications.
Adjust belt tension. (See procedure in this section.)
Specification
Impeller Rotor Sheave
-Torque
339 N·m
(250 lb-ft)
A-Sheave
OUCC006,00002AB -19-16NOV00-4/5
IMPORTANT:
When installing left-hand converging drum shield (A), adjust clearance between shield and converging drum according to specifications.
11.
Install shield (A). Make sure clearance between shield and top of converging drum is according to specifications.