Removing Knives

causym CAUTION: Knives have two cutting edges. Be careful when working around the knives. Knives are sharp and can cause serious injury. Wear gloves when handling knives.

1. To avoid serious injury, rotate both knives on all disks, so they are positioned UNDER the disks.

2. Put a piece of wood between either end disk and outer side sheet.

TS268

OUCC006,00002AC -19-16NOV00-1/2

3. Clean area around special lock nut (A).

4. Rotate disk so knife bolt is over hole (B). Remove knife bolt and nut with socket wrench. Remove knife. If knife bolt is tight, move wear shield or crop accelerator toward center of disk using a hammer.

5. Check knife, bolt, and nut before reinstalling. (See Checking Knives, Checking knife Bolts and Checking knife Nuts in this section.)


A-Lock Nut
B-Hole

CC017218

OUCC006,00002AC -19-16NOV00-2/2