Retracting/Engaging Precutter Knives
NOTE: "Retracting/engaging knives" function use the same selective control valve than to raise/lower the pickup The precutter device allows to chop the crop. In normal operating mode, the symbol "C" (A) is displayed if the knives are engaged and not displayed if the knives are retracted. Press and hold "PRECUTTER KNIFE" key (B) about 3 seconds to select "knives retracting/engaging" function. The buzzer beeps to confirm that the "knives retracting/engaging" function is selected. "CUT" (C) is displayed if the knives are engaged or "NOCUT" (E) if the knives are retracted. Act on selective control valve lever of the tractor (D) to retract or engage the knives. "NOCUT" (E) (knives retracted) or "CUT" (knives engaged) is displayed according to knives position. Press "PRECUTTER KNIFE" key (B) or another key to leave the "knives retracting/engaging" function. The buzzer beeps to confirm that the monitor is gone back to normal operating mode.
|
|
OUCC006,0000401 -19-29MAY01-1/2 |
|
IMPORTANT: When the operator is baling with precutter knives engaged, "NOCUT" should be displayed and an alarm should be emitted if some knives are disengaged during more than 2 seconds. Retract and engage precutter knives several time after each working day to prevent knives jamming. NOTE: When using baler with knives retracted for a long period, it is recommended to remove them all (see "Replacing Precutter Knives" in "Service" section) or to install fillers to plug the knife slot (See "Knife Slot Filler Kit" in "Attachment" section). |
OUCC006,0000401 -19-29MAY01-2/2 |