Adjusting 2.00 m (6 ft 7 in.) Precutter Pickup Height (Pickup without Downstop)
IMPORTANT:
Gauge wheels are designed to be in constant contact with the ground.
Adjust gauge wheels to obtain the desired pickup height as follows:
-
Check first that precutter pickup operating mode is activated.
-
Act on selective control valve lever to fully raise the pickup.
-
Remove spring-locking pins (B) then choose one of the positioning holes (C) to fix support (A) on studs (D). Install spring-locking pins (B).
-
Repeat procedure on opposite side.
-
Act on selective control valve lever to fully lower the pickup.
A-Gauge wheel support
B-Spring-locking pins
C-Positioning holes
D-Studs
|
Wheel removed for clarity
|
