Removing and Servicing Knives (Without Disk Immobilizing Device Only)

Knives are attached to disks by special knife bolts.

Clean area around special nut (A). Turn disks to align knife bolt with hole (B).

Immobilize disks to prevent them from turning while loosening knife bolt.

Remove knife bolt nut using a socket wrench then remove knife screw through hole (B).

Refer to "Checking Knives" and "Checking Knife Bolts" in this Section before reinstalling knives.

A-Nut
B-Hole

AG,OUCC006,349 -19-04MAY00-1/1