|
Before beginning of each season, the mower-conditioner should undergo a thorough check. By ensuring that the machine is in really good condition, breakdown will be avoided.
Reinstall all belts and check belt tension.
Lubricate complete machine. This will force any moisture out of the bearings. See "Lubrication and Maintenance" Section.
Check all hardware for tightness.
Check tire inflation pressure.
Readjust slip clutch springs. Make sure slip clutch has not seized.
Check oil in cutterbar. If necessary, drain and refill with specified amount and quality.
Drain and refill main gear case.
|
Check that all rotor tines are securely fastened.
Check for proper hitching.
Read the Operator's Manual.
Install grouper canvas and adjust tension (see "Replacing Grouper Rubber Band and Canvas" and "Adjusting Grouper Canvas Tension" in the "Service" Section).
Adjust grouper canvas tracking (see "Adjusting Grouper Canvas Tracking" in the "Service" Section).
Attach mower-conditioner to the tractor and check grouper raising and lowering time. Adjust if necessary. (See "Adjusting Grouper Raising and Lowering Time" in the "Service" Section.)
Afterwards run mower-conditioner at half speed for about an hour. Check all bearings for overheating.
|