|
Twine too tight or twine breaks while tying.
|
Twine routing wrong.
|
Check for correct routing.
|
|
|
Bad twine, knots in twine, new ball with tight core, wet twine.
|
Pull out bad twine or replace twine.
|
|
|
Wrong twine tension plate pin or springs.
|
Replace with correct parts.
|
|
Twine too loose on bale.
|
Broken or missing twine tension spring.
|
Replace spring.
|
|
|
Wrong tension spring pin.
|
Replace pin.
|
|
|
Worn twine tension plates.
|
Replace worn parts.
|
|
Twine spacing not constant.
|
PTO rpm change during tying.
|
Keep PTO rpm constant.
|
|
No twine on bale or twine not caught by bale.
|
Twine from end of twine tube too short.
|
With tractor engine shut off, pull out twine until 300 mm (12 in.) is exposed from end of twine arm.
|
|
|
Twine tension too high.
|
See "Twine Too Tight or Twine Breaks While Tying".
|
|
|
Baler out of twine.
|
Add twine. See "Loading Front Twine Box" in "Preparing the Baler" Section.
|
|
Twine too close to edge of bale.
|
On right-hand side: Missing or bent twine guide rod.
|
Replace or straighten rod.
|
|
|
On left-hand side: Support of twine arm actuator misadjusted.
|
Readjust.
|
|
|
Wrong Baletrak control setting.
|
Adjust to correct values.
|
|
|
Barrel shaped bales.
|
Fill ends of bale by crowding windrow. See "Feeding the Material" in "Operating the Baler - General Purposes" Section.
|
| Symptom |
Problem |
Solution |
|
Twine not cut.
|
PTO disengaged before twine is cut.
|
Look at twine to see that it has stopped moving before disengaging PTO.
|
|
|
Twine cutter out of adjustment.
|
Adjust twine cutter. See "Service" Section.
|
|
|
Dull knife or uneven edge not making contact with anvil.
|
Sharpen or replace knife. See "Service" Section.
|
|
|
Knife not parallel to anvil.
|
Position knife pivot shaft so knife makes contact with anvil in area where twine is cut. See "Service" Section.
|
|
|
Obstruction causing twine not to be guided above knife.
|
Remove obstruction.
|
|
|
Bent twine guide rod.
|
Straighten or replace.
|
|
|
Binding in twine arm or cutter linkage.
|
Repair or replace so that linkage operates freely.
|
|
|
Incorrect twine routing or bad ball of twine causing high twine tension.
|
Correct cause of high tension.
|
|
Twine arm moves too slowly from right to left.
|
Battery charge level to low.
|
Check battery charge (at least 20 A).
|
|
Twine arm will not move.
|
Wrong connection on electric cylinder.
|
Repair.
|
|
|
Defective bale tying monitor.
|
Repair or replace as necessary.
|
|
|
Malfunction of bale tying monitor.
|
Check battery charge (at least 20 A).
|