|
The following adjustments should be carried out when net cut or net tying problems occur during field operation.
The following list includes different tests and adjustments to carry out in this order:
1.
Checking galvanized roll flatness.
2.
Adjusting counter-knife position.
|
3.
Adjusting press roll and plastic rollers.
4.
Adjusting net actuator position.
5.
Adjusting rubber roll brake.
6.
Adjusting net cut sensor.
7.
Adjusting net tying drive belt tension.
NOTE:
When all test results are OK, the net tying device is then optimized for good field operation.
|