|
Bale not tied (no "end of cycle" beep).
|
No good contact between galvanized roll and rubber roll.
|
See "Checking Galvanized Roll Flatness" in "Service" section.
|
|
|
Net roll empty.
|
Install a new net roll.
|
|
|
Net drive rolls not engaged.
|
Check net roll rotation using net indicator and check belt tension. See "Adjusting Net Tying Drive Belt Tension" in "Service" section.
Replace drive belt. See "Removing and Installing Net Tying Drive Belt" in "Service" section.
|
|
|
Net rolled up around rubber roll.
|
See "Removing Net Wrapped Around Feed Rolls" in "Service" section.
|
|
|
|
Adjust counter-knife and rubber pad position. See "Adjusting Counter-Knife Position" in "Service" section.
|
|
|
|
Clean feed rolls. See "Care of Net Tying Device" in "Preparing the Baler" section.
|
|
|
|
Check that net roll diameter is not greater than 300 mm (11.8 in.).
|
|
|
Net rolled up around rubber roll after the first bale of the day.
|
Disengage net from net feed rolls if baler must stand over night or more than 10 hours without operation.
|
|
|
Net not engaged properly (new roll).
|
Restart net installation. See "Loading Net Roll" in "Preparing the Baler" section.
|
|
|
Feed rolls sticky or damaged.
|
Clean feed rolls. See "Care of Net Tying Device" in "Preparing the Baler" section.
|
|
|
|
See your John Deere dealer.
|
| Symptom |
Problem |
Solution |
|
|
Net sticky from packaging.
|
Cut off sticky area.
|
|
Bale not tied (with "end of cycle" beep).
|
Net around sticky rolls of baler.
|
Clean the relevant rolls.
|
|
Bale tied (no "end of cycle" beep).
|
Net sensor broken or not adjusted.
|
Adjust and/or replace sensor. See "Adjusting Net Cut Sensor" in "Service" section.
|
|
Bale not uniformly tied or not tied.
|
Net tying cover gas spring(s) defective.
|
Check springs on both sides of the net tying cover. Replace if necessary.
|
|
|
Net tying cover not closed.
|
Cover must be closed for best results.
|
|
|
Net drive belt too long.
|
Replace drive belt. See "Removing and Installing Net Tying Drive Belt" in "Service" section.
|
|
Net not cut.
|
Specified net quality not used.
|
Use recommended net quality.
|
|
|
Electrical components defective.
|
Check and/or replace parts.
|
|
|
Dull knife.
|
Sharpen knife. See "Service" section.
|
|
|
Rubber roll brake not correctly adjusted.
|
Adjust net feed roll brake. See "Adjusting Rubber Roll Brake" in "Service" section.
|
|
|
Counter-knife not all across the width in contact with net knife.
|
Adjust counter-knife position. See "Adjusting Counter-Knife Position" in "Service" section.
|
|
Buzzer stays on after net is cut.
|
Spring missing on net cut detection plate.
|
Replace spring.
|
|
Net not tight around bale.
|
Net tying cover gas spring(s) defective.
|
Check springs on both sides of the net tying cover. Replace if necessary.
|
|
|
Small net roll behind press roll.
|
Check that roll of net (when small) is not behind press roll. See "Preparing the Baler" section.
|