Adjusting 2.00 m (6 ft 7 in.) HiFlow Pickup Gauge Wheels

IMPORTANT: Gauge wheels are not designed to be in constant contact with the ground.

Adjust gauge wheel position as follows:

1. Act on selective control valve lever to fully lower the pickup.

2. Remove spring-locking pin (B) then choose one of the positioning holes (C) to fix support (A) so that gauge wheel is just above the ground (gauge wheel must be approximately at the same height as pickup teeth). Install spring-locking pin (B).

3. Repeat procedure on opposite side.

CC1021577


A-Support
B-Spring-locking pin
C-Positioning holes

CC03745,0000B4A -19-09JUN05-1/1