A-ON/OFF key
B-Twine or net tying key
C-Tying end key (twine only)
D-End tying distance (twine only)

E-Tying start key (twine only)
F-Twine spacing/number of net turns
G-Program key
H-Soft core key

I-Tying auto start bale diameter
J-Bale counters
K-Minus key
L-Plus key

M-Retract key
N-Extend key
O-Manually start an automatic tying cycle

NOTE: When any key is pressed, buzzer will beep.

A short pressure on "PLUS" or "MINUS" keys gives an increment of selected value.

A long pressure on "PLUS" or "MINUS" keys accelerates the increment display.

CC03745,0000C3D -19-16JAN07-1/1