|
Barrel or cone shaped bales on balers equipped with BaleTrak control monitor. Monitor shows a well shaped bale.
|
Bale shape potentiometer out of adjustment.
|
Readjust bale shape potentiometer. See "BaleTrak Monitor Service" section.
|
|
|
Outer belts not of the same length.
|
Shorten belts to the same length within 38 mm (1.49 in.). See "Service" Section.
|
|
|
Broken belt roller arm spring.
|
Replace spring.
|
|
Cone shaped bales on baler without BaleTrak control monitor.
|
Bale shape indicators out of adjustment.
|
Readjust to correct setting. See "Service" Section.
|
|
|
Broken belt roller arm spring.
|
Replace spring.
|
|
Barrel shaped bales on baler without BaleTrak control monitor.
|
Belt roller arms out of adjustment.
|
Adjust belt roller arms. See "Service" Section.
|
|
|
Outer belts too short.
|
Correct belt length. Belts should have the same length within 38 mm (1.49 in.). See "Service" Section.
|
|
Baler does not make dense bales.
|
Internal leak in belt tension hydraulic cylinder.
|
See your John Deere dealer.
|
|
|
Dirty or defective relief valve.
|
See your John Deere dealer.
|
|
|
Bale ends not filled tightly.
|
Crowd more hay in ends of baler. See "Operating the Baler - General Purposes" section.
|
|
|
Density control adjusted for light bales.
|
Adjust for heavier bales. See "Operating the Baler - General Purposes" Section.
|
|
|
Bale forming belts too short.
|
Check length and correct. See "Service" Section.
|