Adjusting Gate Latch Stop (592 Only)Close and latch gate. Push gate latch (A) forward by hand. If the distance between gate latch stop (D) and stop pad (C) is not 2 ± 1 mm (0.08 ± 0.04 in.), insert shims as necessary following this procedure: Loosen bolt (B). NOTE: Shims are slotted so bolt does not have to be removed. If distance is greater than 3 mm (0.12 in.) transfer shims from storage position to shimming position until a distance of 2 ± 1 mm (0.08 ± 0.04 in.) is obtained. If distance is less than 1 mm (0.04 in.) transfer shims from shimming position to storage position until a distance of 2 ± 1 mm (0.08 ± 0.04 in.) is obtained. Center shims and stop pad and tighten bolt (B). If necessary, repeat procedure on opposite side. NOTE: If proper adjustment cannot be obtained, lower gate (tractor engine shut off). If there is a gap on one side of the gate only, see your John Deere dealer and have the gate straightened. |
|
OUCC006,0000369 -19-02APR01-1/1 |