|
Baler does not feed; hay plugged at feed opening.
|
Large windrows and/or ground speed too high.
|
Reduce windrow size and/or tractor ground speed.
|
|
|
Missing pickup teeth.
|
Replace teeth.
|
|
|
Compressor rack too low.
|
Raise rack. See "Operating the Baler - General Purposes" Section.
|
|
|
Gate opening while baling.
|
Repair leaking gate hydraulic cylinders.
|
|
|
|
Adjust gate latch (592 only). See "Service" Section.
Check bale density adjustment. See "Operating the Baler - General Purposes" Section.
|
|
|
Gate not closed.
|
Eject bale. Close gate.
|
|
|
Bale density too high.
|
Decrease density or start with soft core (if equipped). See "Operating the Baler - General Purposes" Section.
|
|
|
Incorrect belt routing.
|
Route belts properly. See "Service" Section.
|
|
|
Slip clutch not adjusted properly.
|
Adjust clutch. See "Service" Section.
|
|
|
Driveline shear bolt sheared.
|
Replace shear bolt. See "Service" Section.
|
|
|
Pickup shear bolt sheared.
|
Replace shear bolt. See "Service" Section.
|
| Symptom |
Problem |
Solution |
|
Baler does not bale short, dry, slick crops.
|
Excessive buildup on top of compressor rack.
|
Remove compressor rack assembly.
Install rubber coated starter roll shells. See "Attachments" Section.
|
|
|
Core does not start to run.
|
Install rubber coated bars on starter roll.
Check that 1.81 m (5 ft 11 in) pickup feeder forks are set in position "2". See "Operating the baler - General Purposes" Section.
|
|
|
PTO speed too high.
|
Reduce PTO speed and shift to higher gear.
|
|
|
Bale density too high.
|
Decrease bale density. See "Operating the Baler - General Purposes" Section.
|
|
|
Pickup too low.
|
Raise pickup. See "Operating the Baler - General Purposes" Section.
|
|
|
Windrow too light.
|
Rake heavier windrows. See "Operating the Baler - General Purposes" Section.
|
|
Baler does not feed cornstalks.
|
Pickup too high.
|
Lower pickup. See "Operating the Baler - General Purposes" Section.
|
|
|
Windrows too large.
|
Rake smaller windrows. See "Operating the Baler - General Purposes" Section.
|
|
|
Missing or broken pickup teeth.
|
Replace teeth.
|