IMPORTANT: Prior to carry out this test, make sure that test 1 to 3 results are "OK". Proceed to the relevant tests described in this Section.

IMPORTANT: Check the position of roll NR 8 after each drive belt replacement.

Proceed as follows:

Check that axial clearance of roll NR 8 (A) is between 0.5 to 1.5 mm (0.02 to 0.06 in.) and that rubber roll (B) and NR 8 roll pulleys are aligned within ±5 mm (2 in.).

Add or remove washers on each sides of roll NR 8 as necessary.

Reinstall net feed roll drive belt. See "Removing And Installing Net Feed Roll Drive Belt" in this Section.

Proceed to test 5.

OUCC006,000039D -19-05APR01-1/1