Removing and Installing Net Feed Roll Drive Belt

Remove net feed roll drive belt as follows:

Fully retract net actuator. Slightly open gate to release pressure on baler belts.

Remove gate roll NR 8 fixing screw (D).

Remove roll support (A).

Release brake lever (B).

Remove drive belt (C).

Reverse removal procedure to install drive belt back in place.

Close the gate and check belt tracking. See "Adjusting Belt Tracking" in this Section.

A-Roll support
B-Brake lever
C-Drive belt
D-Roll NR 8 Fixing screw

OUCC006,0000408 -19-31MAY01-1/1