A-plastic rollers

B-Upper tension arm

C-Cables

D-Lower tension arm

IMPORTANT: Prior to carry out this test, make sure that test 1 to 6 results are "OK". Proceed to the relevant tests described in this Section.

Proceed as follows:

Check that plastic rollers (A) rotate freely. If plastic rollers do not turn with one hand, clean plastic roller axles or adjust maintain circlips.

Check that cables (C) bend as shown while closing lower tension arm (D) and that the cable loops do not prevent fully opening or closing of lower tension arm (D). Open and close at least twice to confirm cables (C) are operating properly.

Proceed to test 8.

OUCC006,000040A -19-06JUN01-1/1